magnetic separation equipment

PTMS MAGNETIC SEPARATOR

what is magnetic separation in Kaolin？

Common troubleshooting methods for permanent magnet drum iron remover:

Before driving the circuit, check the transmission equipment to confirm that the normal equipment is driveable;
The pulp is first added to the water.
In order to maintain good magnetic separation, we should pay attention to the following points: (1) maintain a good lubrication state;
Check the length of the column on the surface of the layer to deal with the loose and broken end time. When repairing, the surface of the broken head and the surface of the rubber band are cleaned with sandpaper and then glued.

Timely remove the iron in the slurry, the electrode head and the like to avoid grinding the barrel.
The permanent magnetic cylinder magnetic separator can be configured with three channels, a semi-reverse flow channel (CTB), a downstream channel (CTS) and a reverse flow channel (CTN) to meet different selection requirements.
If the wear is severe, the surface of the cylinder drum will wear, but once it is worn, it will enter the magnetic roller, and the surface of the magnetic roller will be adsorbed on the magnetic system, which will cause the cylinder and magnetic system to be locked, or the pulp will enter the bearing and cause bearing damage. But the entire machine is not working properly.
Due to the high work intensity, some troubles will inevitably occur during the operation, and the drop of the magnetic block is one of them.
How to deal with the drop of the magnetic separator?
Next, the iron remover manufacturer Wanjiade answers for you: 1. The magnetic block is closed: when the magnetic separator is divided into magnetic separators, the light will rupture the barrel, heavy cylinder or cylinder skin. This phenomenon should stop immediately. .
In order to prevent the magnets from falling off again, we can use thin copper to maintain the magnetic field during the repair process.
The magnetic separator in operation is not normal, and even if the cylinder cannot rotate, the bottom box will vibrate.
Causes of failure: The bottom blowpipe at the bottom of the semi-reverse flow tank is sometimes blocked by calcium, causing the sand tube to clog or the pipeline to block the working gap, sometimes blocking the pipeline blockage, but there are some debris in the working gap to prevent the working gap.
The tailings grade suddenly rises and remains high.
Solution: Notify the machine repair class and stop the weld groove grinding.
Causes of failure: First, poor lubrication or severe wear and tear, B, fan blade falling or wear, C, bad contact or disconnected single-phase operation, D, low pressure.