magnetic separator machine

PTMS magnetic separation

what is magnetic separation in chemistry？

The iron remover is suitable for magnetite ore below 3mm, pyrrhotite, calcined ore and ilmenite wet magnetic separation material, and is also used for iron removal materials such as coal, non-metallic minerals and building materials. The magnetic separator magnetic separation system uses high-quality materials or composite magnets, and the ferrite magnetic drum has an average magnetic induction intensity of 100-100 mt. What are the common magnetic separators? Below we analyze each one by one.

Common failure of iron remover

Overheating, magnetic separation, machine motor and its noise are not normal.

There are several reasons why the iron remover motor is overheated and abnormally sound:

1, the bearing is worn or poorly lubricated;

2, the fan leaves fall off or wear;

3, the switch circuit is in poor contact, or disconnected single-phase operation;

4, the voltage is too low.

Common causes of iron separator failure

Second, the magnetic field strength of the iron remover is weakened.

1, the temperature is too high

2, sunshine

3, acid-base corrosion

Iron separator common fault

Third, the magnetic separator, the sound is abnormal during operation, the cylinder is stuck by the baffle, and even the cylinder and the bottom box cannot be rotated.

1, the bottom of the object is stuck,

2, the magnetic block falls off, causing the barrel to squeak, and in severe cases, the tube skin will break.

When problems such as abnormal noise occur during the operation of the magnetic separator, the maintenance should be stopped immediately to eliminate the malfunction.

Common faults lead to magnetic separator

Fourth, the reducer is overheated

1, lack of oil or greasy;

2, the worm wheel has no wear, or the mesh is not good;

3, the bearing is poorly lubricated or severely worn.

Find out the cause of the device failure, better and solve the problem faster. Iron removal equipment not only requires frequent maintenance, but requires regular maintenance to reduce equipment failure rates.