Magnetic separator manufacturer
PTMS magnetic separation
what is magnetic separation in Kaolin?
The application of strong magnetic separator is widely used in metallurgy, mining, coal preparation, power plants, ceramics, glass, cement, building materials, chemical, food and feed processing industries. In the emerging waste treatment industry, it is also necessary to remove waste from iron separators. In the steel. Iron removers have been used in major steel companies, as well as in metal mines, power plants, light industry, refractory materials, etc., and have played a huge role. Due to the more common use, the internal parts need to be replaced and repaired frequently, and the excitation coil is also very easy to burn out. Some parts may also have some faults without damage, such as non-magnetic faults. Xiaobian introduces the method of removing the magnetic force from the strong magnetic separator. When using the power supply to the strong magnetic separator, the workpiece cannot be held. Due to the relay interlock of the relay, the grinding wheel motor cannot be normal. Start up, so that it can be judged that there is no magnetic fault in the strong magnetic iron remover. At this time, we need to open the power distribution box of the CNC machine tool, and the hook type shot blasting machine uses the test pencil to perform the power check at both ends of the fuse. Then use the 500 volt measurement of the universal meter to measure whether the voltage is 380 volts. Then disconnect the main power switch and check the AC contactor for mechanical jam. US Red Maple then remove the coil and wire of the contactor. Use a multimeter The resistance measurement is the resistance at both ends of the safety. If the indication of the needle is normal, the coil is normal. When we cut off the main switch, use the resistance of the multimeter. The four rectifier diodes are measured separately to observe whether there is any problem with the diode. If the diode is found to be broken down, then replace the new diode and solder it firmly. After testing, the magnetic separator can be used normally.
