water cooling electromagnetic separator for mining

PTMS MAGNETIC SEPARATOR

what is magnetic separation used for?

1. Before starting the machine, the operator must open the observation port cover and check whether there are any large iron parts on the separator inside the iron remover (especially the tap hole). If it is, it must be cleared before it can be turned on.

2. Once the machine has mechanical failure and the production line is temporarily inconvenient to stop, the power of the machine can be turned off, and the operator can remove the iron from the observation port, and the production line can continue to work. However, at the same time, it should be repaired with professionals in time. Non-professionals are not allowed to open the cover without authorization to avoid damage to the machine. Oil sealant seals must be applied before each cover.

3. The dust on the gear motor should be removed every shift; the iron remover should add the calcium grease to the gearing hole of the gear motor and the chain of the machine side every half year; replace the oil in the oil tank at the bottom of the chassis every 12 months, if the temperature of the material is high At 100 ° C, the oil change time should be shortened.

4. The felt strip inside the machine side sprocket cover and the lower felt ring of the large sprocket wheel are designed to ensure the seal of the chassis and effective breathing. It should not be damaged during maintenance; the iron felt ring should be replaced in time after long-term wear and tear.

5. If the powder has a small particle size (≤1mm), the ferromagnetic content is higher. The powder that is entrained in the discharge of the taphole will increase, which is a normal phenomenon. If the amount of discharged materials is large and the user wants to recycle the materials, the company can purchase the permanent magnet sorter of the company's supporting products.