water cooling electromagnetic separator for mining

PTMS MAGNETIC SEPARATOR

what is magnetic separation method in hindi？

First, the ignition timing does not have a great impact on the car. The burning of gasoline in the engine must be ignited by the sparks on the side of the Mars plug. To make the engine run smoothly, and the combustion is good, the spark of the spark plug should be strong enough. OK, but more importantly, the time for the spark to jump out must be correct and correct. Too early and late will affect the horsepower of the engine. The timing of this spark jumping out of the Mars plug is the so-called ignition timing. It is usually expressed by the angle of the crankshaft to the top of the top dead center, such as 10 ° before the top dead center, not in time.

Second, the ignition timing adjustment

1. Adjusting the gap of the contact gap of the distributor's power-off contact not only affects the strength of the spark, but also affects the opening and closing of the contact. If the contact gap is adjusted after adjusting the ignition timing, even a slight change. In the range of 0. 35～0. 40毫米, it is necessary to adjust the contact gap before the ignition timing adjustment.

2. Find the position of the top dead center of the first cylinder compression stroke and loosen the spark plug of the first cylinder. Slowly crank the crankshaft, when the sound of the deflation is heard, it means that the first cylinder is in the compression stroke. Open the inspection hole cover on the flywheel housing and slowly rock the crankshaft to align the timing marks.

3. If there is an octane selector, it should be adjusted to the scale position of "0".

4. Determine the position of the breaker contact just open and loosen the fixing screw of the distributor housing. Rotate the housing first in the direction of the rotation of the distributor shaft so that the two contacts are in the closed position. Then turn on the ignition switch, while rotating the outer casing of the distributor along the opposite direction of the rotation of the distributor shaft, while the high-voltage line of the ignition coil is facing the ground (about 2 to 3 mm) until the spark is found. Finally, tighten the fixing screws of the distributor housing.

5. Connect the high-voltage line according to the ignition sequence: replace the split-fire head, insert the first cylinder high-voltage line into the plug hole of the distributor cover and the split-head conductive sheet, and press the clockwise direction 1, 5, 3, 6, 2 Insert the high voltage line of each cylinder in the order of 4.

6. Start inspection: start the engine to run to normal temperature, and suddenly accelerate. If the engine emits a short and slight knocking sound and disappears immediately, the ignition time is appropriate. If there is no knocking sound, that is, after the ignition time is delayed, the fixing screw of the distributor housing should be loosened and the distributor housing should be rotated a little in the opposite direction to the distributor shaft. If the knocking sound is severe, that is, the ignition time is early, the distributor case should be turned in the opposite direction until it is suitable.