drum magnetic separator

PTMS magnetic separation

what is magnetic bead separation？

In the operation of the belt type iron remover, we are prone to belt deviation, so how can we correct it? Adjust the roller support first. If all the roller bearings have been adjusted in place, the belt will continue to run and adjust the driven roller bearing. That is, according to the direction of the belt prompting direction, the belt is deflected to a certain side, and the roller support is adjusted according to the direction of the belt diagram. If the belt continues to run off, adjust the driven roller bearing housing in the direction shown. We should pay attention to belt adjustment when adjusting: During belt adjustment and shutdown, do not step on the belt, otherwise it will affect the belt adjustment effect. If the belt runs a little to one side, any two phases of the three-phase motor input line can be exchanged, and the belt will move to the other side in the opposite direction, and will stop when moving to the middle of the iron remover. Phase, make the belt run in the normal direction, and then adjust according to the specific adjustment method of the belt running deviation. After the belt is stopped, the belt should be stably operated for 2 hours in the middle of the iron remover. During operation, it should be observed that the running condition should be adjusted in time if there is deviation.