water cooling electromagnetic separator for Quartz

PTMS MAGNETIC SEPARATOR

what is magnetic separation method for concentration of ore?

It should be stated that it is very slow to suck the pulp or the effect of sucking all the time. If you do not suddenly absorb the slurry, the possible reasons are: vacuum system failure, no vacuum or vacuum can not meet the requirements. Check the vacuum pump and vacuum line, the dispensing head, the ceramic plate, etc. for malfunction or air leakage. Whether the ore supply conditions change, such as the type of slurry, mud content, fineness, concentration, etc. After the joint cleaning, the effect of suctioning in 0~2 hours may be good, it may be slightly decreased within 2~4, and it will be worse or worse after 4 hours. In this case, first check whether the backwashing water pressure (instantaneous maximum water pressure should not be lower than 0.08MPa) meets the requirements, and should also be combined with early cleaning (to ensure normal ultrasound, sufficient amount of nitric acid) and extend the joint cleaning time. Check the filtrate discharge. Most likely, because you don't know about this place, you can't avoid the pro: Of course, as the machine and ceramic plates age, the effect of sucking will gradually decrease. Welcome more exchanges, ceramic filter other problems can talk to me privately or see my avatar. If the effect of long-term suction is poor and does not absorb the slurry, the cause should be solved in time.