electromagnetic separator manufacturer

Wet permanent magnet drum PTMS magnetic separator is mainly composed of three main parts: cylinder, magnetic system and box bottom (tank).

PTMS MAGNETIC SEPARATOR

Wet permanent magnet drum PTMS magnetic separator cylinder is made of 2-3 mm stainless steel plate coil welding. The end cap of the cylinder is cast aluminum and is connected to the cylinder with stainless steel screws. Wet permanent magnet drum separator with stainless steel (copper) or aluminum cylinder, because these materials are non-magnetic materials, has a good permeability, so that the magnetic line of force does not form a magnetic short circuit and cylinder. The surface of the cylinder is also covered with a layer of wear-resistant rubber or a layer of fine copper wire as a protective layer, so that the cylinder surface is not worn. At the same time, it is conducive to the attachment of magnetic ore particles on the barrel surface, strengthening the carrying effect of magnetic ore particles on the barrel body, and the cylinder is driven by the motor to rotate.

what is magnetic separation method？

Wet permanent magnet drum PTMS magnetic separator magnetic system is divided into three permanent magnet magnetic system, there are four or multiple poles. The polarity of the magnetic poles is arranged alternately along the direction of rotation of the cylinder and is fixed during operation. When magnetic ore particles are attracted to the surface of the cylinder and rotating with the cylinder, due to polarity alternation and magnetic over (also called magnetic stirring) phenomenon, and the mechanical inclusion in the magnetic ore particles in part of the non-magnetic ore particles removed, can improve the quality of magnetic products.
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com