Remove iron from lithium iron phosphate

The mixed rubber MATERIAL is ejected by pressure and changed into particles required by customers after PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC through spray dryer. Spray dryer a device that can dry and granulate at the same time. According to the process requirements, the pressure, flow rate and the size of the nozzle can be adjusted to obtain the required spherical particles in a certain proportion.

PTMS magnetic separator

The working principle is that the air is filtered and heated and enters the air distributor at the top of the dryer. The hot air enters the drying chamber evenly in a spiral shape. Through the high speed centrifugal atomizer at the top of the tower, the material liquid is sprayed into a very fine mist, which can be dried into the finished product in a very short time after parallel contact with hot air. The finished product is continuously output from the bottom of the drying tower and cyclone separator, iron removal by PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC, and exhaust gas is drained by induced draft fan.

what is magnetic separation used for？

PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC removal filter system
LITHIUM COBALT ACID MATERIAL MAGNETIC removal iron filtration system is to filter the iron in the ternary cathode MATERIAL. When the raw MATERIAL enters the main filter net, part of the fine iron filings will be absorbed by the MAGNETIC like ferromagnetism. Through MAGNETIC adsorption of iron, the iron can be filtered. Then through the filter, so that the three positive material force inside the paste is out.

Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com