Permanent magnet magnetic separator

The general PTMS magnetic separator process is as follows: "raw ore - coarse crushing - medium crushing - pre-screening - grinding - desliming - coarse particle classification - desliming - plate coarse separation - vertical ring high gradient fine separation - fine particle classification - dehydration" for wet production.

PTMS magnetic separation

 
PTMS magnetic separator production process: The shovel truck feeds the raw ore into the silo, and a conveyor is placed at the end of the silo. The raw ore from the tail is uniformly fed to the jaw crushing (coarse breaking) directly below by the vibrating feeder through the conveyor. Then, the coarse material produced is transported by the conveyor to the fine crusher for further crushing. The fine crushed stone enters the vibrating screen, screens out two different sizes of stones and stones, and the large stones exceeding the specifications are returned to the fine crusher and broken again.

what is magnetic separation in Feldspar？

The material under the screen goes into the rod mill, and the material out of the rod mill is graded through the cylinder screen and returned to the rod mill on the screen. The material under the screen enters the blocked settler and the hydraulic classifier for classification. The finished product is separated by high field strength PTMS magnetic separator and high gradient PTMS magnetic separator. After removing iron, the fine sand is dehydrated by the desilting bucket and driven into the sand reservoir.
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com