Magnetic separator

The efficiency of mechanical scrubbing PTMS magnetic separator increases with increasing slurry concentration, because increasing slurry concentration increases the probability of collisions between particles. The research shows that the concentration of sand cleaning is between 50% and 60%. In principle, the scrubbing time is based on the initial product quality requirements, and should not be too long. Because the time is too long, it will increase equipment wear, increase energy consumption and cause an increase in mineral processing costs.

PTMS magnetic separation

 
If the use of dosing strong scrubbing, combined with the appropriate process and PTMS magnetic separator equipment, the use of rod friction washing is better, because dosing can increase the electrical repulsion on the surface of the impurity minerals and quartz particles, enhance the separation between the impurity minerals and quartz particles. The bar abrasion washing test of quartz sand with ore above +0.3mm in a certain place shows that Fe2O3 decreases from 0.19% to 0.10%, and the removal rate of iron reaches 47.4%.

what is magnetic separation in Feldspar？

 
Compared with other iron removal processes, the PTMS magnetic separator process has the following characteristics: 1) the product quality is good, which can meet the quality requirements of float glass for silica sand; 2) Large output. Now small-scale production enterprises and processing enterprises use this method to remove more iron, because it is low cost and simple to operate, but the iron removal rate is relatively low.
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com