Water separation PTMS Electromagnetic Separator is a pretreatment method for quartz sand
water cooling electromagnetic separator for Quartz
As the quartz sand particles become finer, the grade of SiO2 decreases, while the grade of impurity minerals such as iron and aluminum increases. Therefore, it is necessary to conduct PTMS Electromagnetic Separator and desliming classification for the raw quartz sand ore before selection, and the effect is obvious. At present, there are mainly two methods: rod friction washing and mechanical scrubbing.
PTMS magnetic separation
PTMS Electromagnetic Separator is only used as a pre-treatment method for ore selection. It is very early and common, but the effect of removing thin film iron and cohesive impurity minerals present on the surface of quartz sand is not significant. Because there are too many factors affecting it, the recovery rate of mechanical scrubbing is very low, only about 40%, so the effect of mechanical scrubbing is not ideal.
what is magnetic separation method for concentration of ore?
The purpose of scouring PTMS Electromagnetic Separator is to remove the thin film iron, bonded and mud impurity minerals from the surface of quartz sand by mechanical force and the abrasive stripping force between the sand particles, and to further rub the unmonomer mineral aggregate. Then the grading operation achieves the effect of further purification of quartz sand. For mechanical scrubbing, the structure and configuration of the related mechanical equipment, as well as the scrubbing time and scrub concentration in the process are the main factors affecting the scrubbing effect.
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com
