magnetic separator conveyor

PTMS magnetic separation

how to separate two magnets？

What should I do if there is abnormal sound when using a wet PTMS electromagnetic separator? As a rule of thumb, if abnormal noise is detected while using a PTMS PTMS electromagnetic separator, the main problem is the magnetic cylinder and the magnetic block. So what should the customer do now?
Stop the machine first, then check the magnetic cylinder for debris or loose magnetic blocks. As for how to deal with demagnetization caused by magnetic block shedding, the reasons and solutions for demagnetization of permanent magnet drum-type PTMS magnetic separator were explained in detail before PTMS, for customers' reference. The inspection part is the bottom box, to check whether it is stuck by the obstacle; If the magnetic block is not checked for falling off, if the fault is found, it needs to stop for maintenance when troubleshooting, pay attention to personal safety and safe production.
If the magnetic separator is found to have abnormal noise, most of the cases is the magnetic separator into debris, light will shell out marks, heavy stuck cylinder or cylinder skin cut, when this phenomenon should immediately stop to take out obstacles. Bolts, nuts, iron wires and other metal items should not be dropped into the magnetic separator at ordinary times, in order to prevent large ore with slurry into the magnetic separator, should be in the mine to add a screen block block and sundry, and often clean. The magnetic block in the cylinder falls off. At this time, the cylinder has a cracking sound. If the cylinder skin is badly cut, it should be stopped immediately for maintenance to prevent the magnetic block from falling off again. PTMS will continue to sort out the relevant knowledge in the future. If you have any questions, you can also communicate with PTMS.
What are the benefits of magnetic separation?
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com