feldspar processing
PTMS MAGNETIC SEPARATOR
what is magnetic separation method？
The design of cylinder wet PTMS electromagnetic separator tank is directly linked to the effect of the equipment in practical application, so the design of PTMS electromagnetic separator tank needs to pay attention to a lot of problems, here is a simple summary for everyone as follows.
1, tub material is stainless steel plate, the thickness of 4 mm, all welds welded by argon arc welding or carbon dioxide gas shielded welding, after welding flaw detection, ensure the quality of the weld, the tub with cylinder will not leak during the process of operation, in the tub wears location using manganese steel, improve the wear-resisting performance of the tub, prolong the service life of the tub.
2. The bottom surface structure of the feeding part of the tank adopts an arc surface structure, which is different from the traditional straight surface structure at the bottom of the feeding end of the tank. The advantages of this structure are as follows:
(a) can prevent the tank bottom material deposition, so that the slurry flow more smoothly.
(2) The impact of materials on the bottom of the tank is slowed down due to the existence of arc-shaped surface.
3. The tailings discharge pipe of the tank body adopts double-layer pipe structure, and the two layers of pipe are filled with wear-resisting material (epoxy resin + quartz sand), which extends the service life of the tailings pipe.
4. The tank and the frame adopt the modular design, which is firm and firm. The fixed support and adjusting pad at both ends of the tank can be adjusted up, down, and left and right within a certain range.
5. The flushing pipe of wet PTMS electromagnetic separator for ore mixing adopts steel tube structure. The purpose is to locate the direction of flushing and avoid the high-pressure water directly washing the tank box plate.
6. In the feeding area of the cylinder wet PTMS electromagnetic separator, the diameter of the flushing pipe is increased, the water supply flow is increased, and the pressure of the water supply is enhanced to make the water supply more sufficient, avoid the silting of materials in the tank bottom, make the slurry flow more smooth, and effectively improve the magnetic separation output.
7. The wet PTMS electromagnetic separator is equipped with a duck-tip nozzle with a valve for discharging and flushing water, which has a good unloading effect and is water-saving, easy to clean and not blocked.
How can you separate magnetic substances from non magnetic substances?
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com
