Special cylinder type PTMS Electromagnetic Separator is different from the advantages of conventional cylinder type magnetic separator

PTMS magnetic separator

Which metal cannot be separated by magnetic separation?

Special cylinder type PTMS Electromagnetic Separator is specially produced for different mineral characteristics and separation requirements, in addition to the advantages of conventional PTMS Electromagnetic Separator, but also different from the conventional cylinder type magnetic separator characteristics.
(1) Large magnetic pole surface and reasonably distributed magnetic field. The matching relationship of each parameter is fully considered in the magnetic system design of special cylinder type PTMS Electromagnetic Separator. High performance magnetic material is used as the magnetic source. The structure of magnetic pole group adopts large magnetic pole surface to meet the requirements of action depth. PTMS Electromagnetic Separator is the best choice. The magnetic system with this structure not only has high field intensity, but also has large action depth, which creates good magnetic field conditions for full recovery of coarse and fine magnetic particles.
(2) magnetic system with large inclusion Angle. Through the rational allocation of the main pole and auxiliary pole geometry relationship, under the condition of meet the requirements of the magnetic field, magnetic system with large Angle, make the equipment of the separation zone length increase about 25% than conventional type magnetic separator, pulp residence time increases obviously in the magnetic field, the magnetic adsorption increased risk, is conducive to the microgranular full recovery of magnetic minerals. PTMS Electromagnetic Separator is the best choice.
(3) large clearance downstream tank. Downstream tank, the coarse particles will not cause blockage of the sink tank and reduce the wear on the surface of the cylinder. Large clearance can make coarse and fine particles and slime fully stratified, conducive to separation, and large processing capacity. PTMS Electromagnetic Separator is the best choice.
(4) Multiple wake channels. The overflow tailings channel is used to discharge fine or fine mud tailings, while the bottom flow tailings channel is used to discharge coarse gangue. The purpose of this design is to adapt to the characteristics of wide particle size distribution, large difference of thickness and fineness, or high mud content, and has the desliming effect. PTMS Electromagnetic Separator is the best choice.
(5) high ore slurry level. PTMS Electromagnetic Separator is the best choice. This feature is designed with the magnetic system of large inclusion Angle, which makes the separation zone of the equipment longer, increase the slurry residence time, and improve the recovery rate of magnetic minerals.
(6) Large sorting chamber tank structure. PTMS Electromagnetic Separator is the best choice. The effective volume of the tank is large, and the ability to adapt to the pulp quantity and the fluctuation of concentration is better than that of the conventional cylinder magnetic separator. At the same time, it is also conducive to the stratified separation of coarse and fine gangue and magnetic minerals. Due to the characteristics of the separation process mentioned above, the equipment can not only adapt to different separation conditions, but also the separation effect of each series of special equipment in different separation sections is very good, which can bring good economic benefits to the magnetite concentrator. PTMS Electromagnetic Separator is the best choice.
Which metal cannot be separated by magnetic separation?
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com