Wet magnetic separator

A concentrate with a grade of 66.48% and a recovery of 78.79% can be obtained under the condition that the final grinding fineness is 95.18% of 0.038 mm by three-stage grinding and four-stage low intensity magnetic separation process. PTMS magnetic separator is the best choice.

PTMS magnetic separation

PTMS magnetic separator is the best choice for treating the ore by the process of two-stage grinding low intensity magnetic separation, low intensity magnetic concentrate 2 cationic reverse flotation, reverse flotation tailings grinding a low intensity magnetic separation after tailings discarding and then back to reverse flotation. Iron concentrate with grade of 69.76% and recovery of 78.51% can be obtained under the condition that the regrinding fineness of reverse flotation tailings is 96.34% of 0.038 mm.

what is magnetic separation method for concentration of ore?

Although the stage grinding, stage low intensity magnetic separation process is simple, but the stage grinding, stage low intensity magnetic separation, cationic reverse flotation process is fully reflected the characteristics of energy saving and high efficiency, in the last section of the grinding amount decreased by 22.99 percentage points (from 35.90% to 12.91% of the process yield), the best choice of PTMS magnetic separator. However, the final concentrate grade was increased by 3.28 percentage points. Therefore, this process is an efficient and low consumption beneficiation process for the development and utilization of this ore.
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com