eriz magnetic separator
PTMS magnetic separation
what is magnetic separation method？
Xiaobian tells you how to choose the iron remover:
1. The iron remover should be selected correctly according to the requirements of the impurity exchange rate, the iron content of the material, and the working environment on the spot.
a. When the material layer is thick and the material particle size is large, the super magnetic separator should be used; or the large class 1 or large class 2 super model should use ordinary iron remover; multi-stage iron removal; multi-level iron removal should be as much as possible Use iron to install on the head of the belt conveyor.
b. When the requirement for the removal rate of the miscellaneous iron is high, the Qingdao shot blasting machine can also be used with the iron removal equipment of different working modes. For example, the head of the belt conveyor adopts a permanent magnet roller, and the middle of the belt conveyor adopts a belt type iron remover.
c. When the dust in the site is serious, the iron remover with a fully enclosed structure should be used.
d. When the power capacity is insufficient, the permanent magnet separator should be used.
e. When the material contains more iron, the self-unloading iron remover should be used.
2. When the iron remover is installed on the head of the belt conveyor, the hook type shot blasting machine is in a loose state when leaving the belt due to the inertial force of the material, which is good for removing iron. If the drive of the belt head is changed to non-magnetic material, Iron removal will be better.
3. When the iron remover is removed from the middle of the belt conveyor, the idler roller under the iron remover can be changed to a non-magnetic flat roller, which can further improve the de-losing effect.
4. When using multi-stage iron removal, the iron removal force of the latter stage should be higher than that of the former stage. Otherwise, the iron removal effect will be removed.
5, belt conveyor bandwidth below 1400mm is recommended to use the type of permanent magnet iron remover, the United States red maple belt machine bandwidth of 1600mm or more is recommended to use electromagnetic separator.
6. When the site environment is special and the situation is complicated, we will specially design for the user to meet the actual working conditions.
7. The hanging device of the iron remover should be selected according to the actual needs of the on-site working environment. It should be purchased according to the hanging position of the iron remover and the environmental conditions.
