high intensity magnetic separator

PTMS magnetic separator shell is made of 3 ~ 4mm thick stainless steel plate. If there is no protective layer (also called wear layer) on the surface of the shell, it will wear out in a short time and cannot be used. Affect production and increase equipment maintenance costs.

PTMS magnetic separator

Therefore, PTMS magnetic separator shell must choose a protective layer for protection, the existing magnetic separator shell wear-resistant layer protection materials are as follows: 1) vulcanized rubber skin. Choose high-quality wear-resistant rubber, according to the length and diameter of the shell wrapped on the shell, the thickness of 1 ~ 3mm. This kind of material, wear-resistant, long life, but high cost. 2) Apply epoxy resin layer. This method is more complicated to use, so it is not widely used.

how to separate two magnets ?

3)Wrapped copper wire or aluminum wire. At present, some factories use waste aluminum wire winding shell as wear-resisting layer, the effect is good, the cost is not high. 4) Spray asphalt on the shell. This method is simple and easy to operate, the cost is very low and the effect is very good. When spraying, the surface thickness must be uniform to prevent uneven thickness and affect the magnetic field intensity. PTMS magnetic separator can remove iron (FE2O3) inside.
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com