Materials that have undergone PTMS Magnetic Separator re-election and general election are excluded from ferric trioxide and ferric tetrooxide
wet separator
The process of Feldspar beneficiation equipment is as follows: Firstly, the large stones are crushed by jaw crusher. The broken stone is ball ground with a ball mill. 20-200 mesh of fine powder material is sent to spiral chute for separation and sorting to select sediment. The material removed from the sediment after PTMS magnetic separator separation is sent to the shaker to wash out the iron trioxide;
PTMS magnetic separator
The material to remove the iron trioxide is sent to the strong magnetic PTMS magnetic separator for selection, iron and mica material is selected, and then the material is sent to the ordinary magnetic separator, and then separated again; Note: At present, the use of a magnetic separator is not suitable for all Feldspar mines except the iron in Feldspar, and the flotation process has been widely used at present.
how to separate two magnets?
The material through PTMS Magnetic separator re-election and universal suffrage is sent to high frequency vibrating screen screening, removing the iron trioxide and iron tetroxide in the material powder, potassium feldspar fine powder is obtained; Sulfuric acid was used as acid washing agent, and the iron content of Feldspar fine powder was blended according to the concentration of acid and the iron content of Feldspar fine powder. When the concentration of sulfuric acid was determined, the iron content of potassium Feldspar fine powder was proportional to the weight of sulfuric acid added. After pickling, ferric trioxide and ferric tetroxide were completely removed, and the ferrous sulfate solution was separated to obtain Feldspar fine powder.
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com
