magnetic separator for sale
After the mined raw ore is crushed to 25.4mm by hammer crusher, it is put into cage crushing to reduce the particle size to 6.35mm. The hot air in cage crushing reduces the moisture content of kaolin from 20% to 10%. The crushed ore is further milled by an air-blown process with centrifugal PTMS magnetic separator and cyclone dust removal. This process removes most of the sand and gravel. The product is commonly used as a low-cost filler in the rubber, plastics and paper industries.
PTMS magnetic separation
When the whiteness and other requirements of the product are high, dry PTMS magnetic separator must be used to remove iron from the product. The advantages of dry process are that it can save the process of dehydration and dry operation, reduce the loss of ash powder, short process, low production cost, suitable for drought and water shortage areas. But to obtain high purity and high quality kaolin it must rely on wet process.
how to separate two magnets?
The wet PTMS magnetic separator process consists of three stages: ore preparation, mineral processing and product treatment. The preparation phase includes batching, crushing and ramming operations. Ramming is to mix kaolin ore with water and dispersant in the pulping machine, the ramming operation can make the raw ore dispersed, for the preparation of appropriate fineness kaolin slurry for the separation operation, and at the same time remove large grit sand.
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com
