magnetic separator machine

PTMS magnetic separation

what is magnetic separation used for？

hose who do mining should know the iron remover, but few people can know the specific work of the iron remover process. Here is a brief introduction to the specific work process of the iron remover.

1. Before the iron remover works, it must be checked whether each operator is normal. The radial guide rails are cleaned with a fine cotton cloth and oiled according to the lubricating oil brand.

2. The rocker arm and the various parts of the headstock are locked for operation.

3. There is no obstacle in the radial rotation range of the iron remover.

4. Open before breaking, mechanical iron remover, iron remover workbench, artifacts, fixtures, cutting, must find a positive, tightened.

Working process of iron remover

5. The iron separator should correctly select the spindle speed and feed rate, and do not use overload.

6. Outside the drilling table, the workpiece must be smooth.

7. When the mechanical machine is running and automatic feeding, do not tighten the speed change. If the variable can only stay on the spindle, it will stop completely.

8. When the magnetic separator and the measuring workpiece are loaded and unloaded, it must be stopped. Do not drill directly with the workpiece, and do not wear gloves.

9. The work finds abnormal noise and must stop checking for troubleshooting immediately.

The above is the relevant content of the working process of the iron remover, I hope to be helpful to you.