magnetic separator machine

PTMS magnetic separation

how to separate two magnets？

The wet weak magnetic field PTMS electromagnetic separator consists of three main parts: cylinder, magnetic system and tank bottom Composition. The cylinder is welded with a 2-3 mm stainless steel plate. The end cover of the cylinder is cast aluminum, connected with a stainless steel screw and the cylinder. Use stainless steel (copper) or aluminum to do the barrel, because these materials are non-magnetic materials, with good permeability ability, this can make the magnetic field line and the barrel will not form a magnetic short circuit.

The cylinder surface is also covered with a layer of wear-resistant rubber or wrapped with a layer of fine copper wire as a protective layer, so that the cylinder surface will not be worn. At the same time, it is conducive to the attachment of magnetic particles on the cylinder surface, and strengthens the carrying effect of the cylinder on magnetic particles. The cylinder is driven by an electric motor to rotate.

The magnetic system is a three-pole permanent magnetic system, there are also quadrupole or multipole magnetic system. The poles are arranged alternately in the direction of rotation around the cylinder and remain stationary while working. When magnetic particles are attracted to the surface of the cylinder and rotate with the cylinder, magnetic flipping (also known as magnetic stirring) will occur due to alternating polarity, and part of non-magnetic particles in the mechanical inclusion in the magnetic particles will be removed, which can improve the quality of magnetic products.
Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com

Which metal cannot be separated by magnetic separation?